1.Product Description
1.1 Category:Electrostatic flocking paste
1.2 Features:Application for Suede effect, good fastness, soft feel
1.3 Applicable fabrics:Suitable for cotton fabric, polyester fabric, cotton-polyester blend,etc
1.4 Storage:Keep sealed and store in a cool and ventilated place between 5-40℃ of temperature
1.5 Eco-friendly:Compliant with OEKO-TEX and other relevant standards
2.Application Ratio
2.1 It needs to add 1% PC200 additives when use this product.
3.Printing Process
3.1 Printing condition
A. It is recommended to operate under 40% to 70%humidity conditions,and pay attention to the effect of temperature on operability.When the humiditshuy is higher than 70%,the heating time shall be appropriately extended to avoid the surface becoming sticky and the washing fastness becoming poor;when the humidity is lower than 40%,1-3%moisturizer shall be added to prevent the screen from blocking.
B. (Squeegee:55-65 hardness oily squeegee
C. Mesh:100-120 mesh
D. Curing conditions:130-135℃ for 2 minutes
4.Performance Of Printed Products
| Test Project | 309 | Test Method |
| Flexibility | Level 4 | Internal standard:Level5 very soft |
| Machine wash fastness | Pass | 40℃Water temperature,20g of phosphate free laundry detergent,1000 rpm,standard wash for 90 minutes*5 times |
Note :The product performance and application data listed above were obtained under specific experimental conditions,and the actual usage environment of the product is variable.Customers need to undergo testing before mass production.For any unclear information,please contact Guangdong Caigle Technology Co.,Ltd.We reserve the right to revise the product manual without further notice.
5.Frequently Asked Questions
| Problem | Possible Cause | Solution |
| Poor tomentum fastness | 1.The paste has surface dried before flocking | 1.Flocking immediately after the last paste printing |
| 2.Insufficient overheating temperature and time | 2.Overheating at 130-135℃ for 2 minutes | |
| 3.The thickness of the paste is insufficient | 3.Increase the number of prints | |
| 4.Flocking equipment parameters are not suitable | 4.Re-adjust the flocking equipment parameters | |
| Tomentum decolorization | Cotton tomentum was used | Switch to polyester tomentum |
