1. Product Description
1.1 Category:Low-mediumtemperature forming paste
1.2 Features:Application for manually printing and machine printing, resistant to collapse at high temperature
1.3 Applicable fabrics:cotton,knitted,polyester fabric,etc
1.4 Storage:Keep sealed and store in a cool and ventilated place between 5-40℃ of temperature
1.5 Eco-friendly:Compliant with OEKO-TEX and other relevant standards
2.ApplicationRatio
Note:The foaming height is determined by adjusting the addition ratio of the foaming paste.
3. Printing Process
3.1 Printing condition
A. It is recommended to operate under 40% to 70%humidity conditions,and pay attention to the effect of temperature on operability.When the humiditshuy is higher than 70%,the heating time shall be appropriately extended to avoid the surface becoming sticky and the washing fastness becoming poor;when the humidity is lower than 40%,1-3%moisturizer shall be added to prevent the screen from blocking.
B. Squeegee:55-65 hardness oily squeegee
C. Mesh:100-120 mesh
D. Curing conditions:130-135℃ for 60-90 seconds，or 135℃ pressing 10-15 seconds
4. Performance Of Printed Products
| Test Project | 314 | Test Method |
|---|---|---|
| Flexibility | Level 3 | Internal standard: Level 5 very soft |
| Machine wash fastness | Pass | 40℃Water temperature,20g of phosphate free laundry detergent,1000 rpm,standard wash for 90 minutes*5 times |
5. Frequently Asked Questions
| Problem | Possible Cause | Solution |
| Poor foaming effect | The internal moisture was not completely dried, and the rapid evaporation of high-temperature moisture caused the surface to be uneven and granular | Dry at room temperature or bake at low temperature until dry |
| Insufficient overheating temperature and time | Overheating at 130-135℃ for 90 seconds | |
| Screen Plugging | The scraping is uneven and the surface is not smooth | Clean the screen plate and unclog the printed scre en plate |
